Oh and HDMI to LG 1080P IPS LED monitor. The Pi displays the desktop and menu bar in 45 seconds from power on. The hub shows it's powered with a small blue LED but the Transcend USB drive is not lit up. About 5 seconds later the blue LED inside the Transcend blips and then turns on. And the file explorer shows up on the desktop. All about 5 to 8 seconds.
After that, I can switch back and forth between systems. As can the Beagle if the keyboard/mouse switch was plugged into the USB port. I'll try it with just the Transcend USB drive. Maybe then it will realize the USB port is active. John > -----Original Message----- > From: [email protected] [mailto:[email protected]] On > Behalf Of John Dammeyer > Sent: May-16-21 8:15 PM > To: 'Robert Nelson' > Cc: 'Beagle Board' > Subject: RE: [beagleboard] Configure CAN0 with buildroot > > With a 2A 5V supply. No capes installed. Only Ethernet connected and the 4 > port USB 2.0 hub is also powered with a 2A supply > John > > > -----Original Message----- > > From: Robert Nelson [mailto:[email protected]] > > Sent: May-16-21 7:05 PM > > To: John Dammeyer > > Cc: Beagle Board > > Subject: Re: [beagleboard] Configure CAN0 with buildroot > > > > On Sun, May 16, 2021 at 8:55 PM John Dammeyer <[email protected]> > > wrote: > > > > > > Oh and just for interest. Boot a Pi3 with Linux raspberrypi 5.10.17-v7+ > > > and nothing in the USB port and screen shows up as > > expected. Plug same 4 port hub with the connect the the USB switch and a > > 4GB USB drive. Then press the button to change from > > workstation to Pi and about 5 seconds later the mouse and keyboard work nd > > in the /media/pi/Transcend are the files on the USB > > drive. > > > > > > On the Beagle the little blue LED on the USB drive doesn't even light up. > > > > > > I kind of think the BBB should be able to do this too. > > > > Is the USB hub powered externally? How are you powering the Beagle? > > > > Regards, > > > > -- > > Robert Nelson > > https://rcn-ee.com/ > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/beagleboard/0e7901d74aca%24d8d90730%248a8b1590%24%40autoartisans.com. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/0e7a01d74acc%24477e6ad0%24d67b4070%24%40autoartisans.com.
