With a 2A 5V supply. No capes installed. Only Ethernet connected and the 4 port USB 2.0 hub is also powered with a 2A supply John
> -----Original Message----- > From: Robert Nelson [mailto:[email protected]] > Sent: May-16-21 7:05 PM > To: John Dammeyer > Cc: Beagle Board > Subject: Re: [beagleboard] Configure CAN0 with buildroot > > On Sun, May 16, 2021 at 8:55 PM John Dammeyer <[email protected]> wrote: > > > > Oh and just for interest. Boot a Pi3 with Linux raspberrypi 5.10.17-v7+ > > and nothing in the USB port and screen shows up as > expected. Plug same 4 port hub with the connect the the USB switch and a 4GB > USB drive. Then press the button to change from > workstation to Pi and about 5 seconds later the mouse and keyboard work nd in > the /media/pi/Transcend are the files on the USB > drive. > > > > On the Beagle the little blue LED on the USB drive doesn't even light up. > > > > I kind of think the BBB should be able to do this too. > > Is the USB hub powered externally? How are you powering the Beagle? > > Regards, > > -- > Robert Nelson > https://rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/0e7901d74aca%24d8d90730%248a8b1590%24%40autoartisans.com.
