On Sat, 27 May 2000 18:38:55 -0500, Mikkel L. Ellertson wrote: >At 06:38 PM 5/27/00 -0400, you wrote: >>Hi, >> >>I had two scsi hard drives on my system, The first had winNT on and the >second OS2. >>I use System Commander to boot between them. >> >>I installed a new 10 G ide hard drive which is master on the 1st ide >controller. >>I tried to install redhat on this. >>The install went well but when I try to boot linux from system commander I >get LIL and >>thats it. >> >>It boots fine from the boot floppy I made during the install. >>i installed LILO on the ist partition which was the root partition which >is 1000M. >>I have never had this problem before installing redhat. >> >>Can anyone help? >> >> >>Thanks >>Rick >> >>Rick Knebel >>[EMAIL PROTECTED] >> >> >Is your BIOS set to boot from the SCSI drives? If so, try adding a couple of >lines to /etc/lilo.conf: > >disk=/dev/hda >bios=0x83 > >This will tell LILO that your IDE drive is the third drive that the BIOS sees. Thanks for your reply. I put that in lilo.conf and when I booted I got a bunch of 0's running across the screen. Where exactly do i put these two lines in lilo. Thanks Rick > >Mikkel >-- > Do not meddle in the affairs of dragons, > for you are crunchy and taste good with ketchup. > Rick Knebel [EMAIL PROTECTED] -- To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe" as the Subject.
