At 06:38 PM 5/27/00 -0400, you wrote:
>Hi,
>
>I had two scsi hard drives on my system, The first had winNT on and the
second OS2.
>I use System Commander to boot between them.
>
>I installed a new 10 G ide hard drive which is master on the 1st ide
controller.
>I tried to install redhat on this.
>The install went well but when I try to boot linux from system commander I
get LIL and
>thats it.
>
>It boots fine from the boot floppy I made during the install.
>i installed LILO on the ist partition which was the root partition which
is 1000M.
>I have never had this problem before installing redhat.
>
>Can anyone help?
>
>
>Thanks
>Rick
>
>Rick Knebel
>[EMAIL PROTECTED]
>
>
Is your BIOS set to boot from the SCSI drives? If so, try adding a couple of
lines to /etc/lilo.conf:
disk=/dev/hda
bios=0x83
This will tell LILO that your IDE drive is the third drive that the BIOS sees.
Mikkel
--
Do not meddle in the affairs of dragons,
for you are crunchy and taste good with ketchup.
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
