That's how we have been doing it to, up to this point.
In this case the HW engineer is implementing a serial transfer protocol in the CPLD to allow PCI transfer of the image.
Thank You.
Eric O. Heinicke [EMAIL PROTECTED]
BAE SYSTEMS Voice:631.262.8644
Fax: 631.262.8657
One Hazeltine Way, MS 1-78
Greenlawn, NY 11740-1606
> -----Original Message-----
> From: Wesley Hosking [mailto:[EMAIL PROTECTED]]
> Sent: Monday, October 09, 2000 20:00
> To: Heinicke, Eric
> Subject: [rtl] Programming a FPGA
>
>
> Heinicke, Eric writes:
> > Does anyone know of any driver code that shows the
> programming of a FPGA on
> > the target device board, from a file on the system disk?
> >
> I think that you can only do this via a JTAG connection....
> (and that is device specific ).
>
> Usually, you load an FPGA from a memory (Flash, etc.) when it boots
> up. (Thats what we do to our Xilinx chips on our board).
>
> wes
>
