> I then compiled kernel 2.2.14 on it, using the same SCSI module (tried it
> both compiled AND module) and it panics at boot with 0 scsi hosts
> detected.
> 
> I've tried using the module with "options aix7xxx io=E400h irq=10" in
> conf.modules which were the same resources shown in NT before I put it
> down :) but nothing worked.

        Unless you're also setting up an initial ramdisk with the SCSI card
support in it, don't compile your SCSI card support as a MODULE. Compile
it as built into the kernel, and all should work fine. Incidentally, for
whoever originally replied to this, the Adaptec 7800 series cards should
all work great with linux (every one I've used has)...

Matt

  ------------------------------------------------------------------
            Matt Housh            Morpheus.Net Administrator
    email: ([EMAIL PROTECTED]) web: (http://jaeger.morpheus.net/)
  ------------------------------------------------------------------

you played me well, mortal. but i have played me for time out of mind.


-- 
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.

Reply via email to