Hi,
Have a Tyan S1836 mb with onboard SCSI; AIC 7895. I just installed RH 6.1
on it, and it detected the hard drives & cdrom running off the scsi
controller and works great.
I then compiled kernel 2.2.14 on it, using the same SCSI module (tried it
both compiled AND module) and it panics at boot with 0 scsi hosts
detected.
I've tried using the module with "options aix7xxx io=E400h irq=10" in
conf.modules which were the same resources shown in NT before I put it
down :) but nothing worked.
Any ideas on this? Not making me look good since the RAID controller
already didnt work so we pulled it out. :\
Thanks in advance!
Bryan
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
