Re: Installed a new tape drive, where is the device

[Douglas Phillipson]

OK I reinstalled RH AS 2.1 and it now sees the tape at /dev/st0.  What 
program is it that discovers hardware during an install that I can use 
post install to discover SCSI stuff?  I just wish there was a command 
,like Solaris has, for adding new SCSI devices on the fly.  My lack of 
RH experience is probably at fault here...

Problem solved, thanks to those that replied.  As usual Open Source 
support is superior to M$ support.

Regards

Doug P

Lonnie Percent wrote:
i'm not sure if this applies to you.
i had to download and install the mt tape handling software
then, cause we have a dell too
i had to remove the tabe drive connection to the scsi  controller card
and add it to the internal adapetic controller card
tape device is /dev/st0




--
redhat-list mailing list
unsubscribe mailto:[EMAIL PROTECTED]
https://www.redhat.com/mailman/listinfo/redhat-list