whee!! time to cannabalize the 486! stupid compaq didnt give me a three connector
cable.. but i remember seeing it on the 486.. 8) thank you thank you thank you!!!
as soon as i dissect the 486, i'm gonna.. *sniff* FORMAT and then resetup win95
and try linux!!! time to make the leap! thank you! hopefully, i'll be contacting
you again through netscape on linux!!!
thank you muches and muches!
dominic
Rich Shepard wrote:
> At 11:00 PM 5/17/98 -0700, you wrote:
>
> >yeah.. i have two different hard drives, both E/IDE, and they are not on the
> >same cable.. one is attached by cable to a Ultra IDE Controller thing, (the
> >maxtor) the other attached by a cable to the motherboard.. what do you mean
> >by the end connector?thank you sooo much for helping me! thank you thank you
> >thank you!
> >dominic
>
> The 40-wire data cable for the hard drive should have 3 connectors on it.
> One plugs into the socket on the mother board or the interface board and
> the other two are for drives. The master drive should go on the end
> connector and the slave drive should go on the middle one.
>
> Every drive has a set of 3 pairs of pins which are used to configure the
> drive. Many of these sets are along the back edge between the data and
> power connectors; others are on the circuit board. The pins are jumpered to
> designate the drive as Master, Slave or Cable select. The latter case is
> usually not used, but *should* configure the drive based on its position on
> the cable.
>
> Check your two drives to ensure they are configured properly. You should
> be able to put them on the same cable and system connector, but that's not
> required.
>
> As far as I know (AFAIK), there's E/IDE and UDMA. The IDE and EIDE drives
> are functionally equivalent. The Ultra Direct Memory Access (UDMA) take a
> different connector, but are backward-compatible with the EIDE drives and
> can live on the same cable/connector.
>
> >ps what does HTH stand for? ;)
>
> Hope This Helps.
>
> Rich
>
> Dr. Richard B. Shepard, President
> Applied Ecosystem Services, Inc.
> 2404 SW 22nd Street
> Troutdale, OR 97060-1247 USA
> (503) 667-4517 | (503) 667-8863 - fax
>
> --
> PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
> http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips /mailing-lists
> To unsubscribe: mail [EMAIL PROTECTED] with
> "unsubscribe" as the Subject.
--
PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips /mailing-lists
To unsubscribe: mail [EMAIL PROTECTED] with
"unsubscribe" as the Subject.
