> On 23 Nov 2019, at 19:42, sliptonic <[email protected]> wrote:
>
> I converted my mill back to linuxcnc a while back because of compatibility
> problems with gmoccapy.
> However, I'd like to experiment with mlampert's machinekit workbench in
> FreeCAD.
>
> Is it possible to install both side-by-side? (Debian stretch)
>
> Any gotchas to be aware of?
As far as i’m aware of you can install both as a RIP (run in place) built from
source.
Then running the rip-environment script from one of both allows you to use one
of both
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups
"Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/machinekit/5F657F84-F64B-442A-8268-61055368C351%40basdebruijn.com.
