On Thursday, January 18, 2018 at 1:07:36 PM UTC-5, gary wrote: > > The first link didn't work... > It's not a link. Look on your device. That directory contains the predefined macros related to FDM. They need to be defined in your ini to exist.
> on the BeBoPr++ i thought i changed this > net e0.temp.set => pid.0.command > to this > net e0.temp.set motion.analog-out-01 => pid.0.command > to get it to work with the m104 halcmd sets e0,temp.set macro > or something close its been a while and really not totally sure how i did > it way back when i started.. > > but didn't seen to work with the cramps board > > I am getting a different error with the macro now, shell script unsigned > int > > Not being a programmer its a little tough figuring all this out.. > I hate to give up on it now seeing its close to the last thing i need to > get running, I spent a lot of time getting all the axis's calibrated and > extruder. > Those numbers will transfer nicely. Just make sure to keep them. > but if i can't get the macros working it's not going to work, and i will > have to switch to a different controller again.. > > Thanks gary > > I think you started this the hard way. :) Probably good for learning, but not as good for just getting things working. Velocity extrusion configs would likely be easier to adapt, but they are also generally designed to work with machinetalk for a remote interface and use the newer pythonic configuration style. > On Saturday, January 6, 2018 at 8:42:16 PM UTC-5, gary wrote: > >> I just connected a BBB and Cramps board to my delta printer, but i have >> been having homing problem >> I have optic switches installed if i go into the hal configuration when >> machinekit it booted, and then to the show window with xmax ymax and zmax >> displayed then when axis's are off the switches there red, and when i >> trigger the switches they turn yellow >> So i assume the switches are working and being read by the software. >> >> But when i do home all the motors they move up to the switches in the >> correct direction but never stop just keeps running into the optic >> end stops and i have to power down.. >> >> any suggestions? >> >> Thanks gary >> > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
