The first link didn't work... on the BeBoPr++ i thought i changed this net e0.temp.set => pid.0.command to this net e0.temp.set motion.analog-out-01 => pid.0.command to get it to work with the m104 halcmd sets e0,temp.set macro or something close its been a while and really not totally sure how i did it way back when i started..
but didn't seen to work with the cramps board I am getting a different error with the macro now, shell script unsigned int Not being a programmer its a little tough figuring all this out.. I hate to give up on it now seeing its close to the last thing i need to get running, I spent a lot of time getting all the axis's calibrated and extruder. but if i can't get the macros working it's not going to work, and i will have to switch to a different controller again.. Thanks gary On Saturday, January 6, 2018 at 8:42:16 PM UTC-5, gary wrote: > I just connected a BBB and Cramps board to my delta printer, but i have > been having homing problem > I have optic switches installed if i go into the hal configuration when > machinekit it booted, and then to the show window with xmax ymax and zmax > displayed then when axis's are off the switches there red, and when i > trigger the switches they turn yellow > So i assume the switches are working and being read by the software. > > But when i do home all the motors they move up to the switches in the > correct direction but never stop just keeps running into the optic > end stops and i have to power down.. > > any suggestions? > > Thanks gary > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
