I got it to work i had to change remove the - from scale and also the - from HOME_SEARCH_VEL and now seems to be work correct with the gcode..
Been looking for some hal commands to change the axis's values like when calibrating the corners and center setting position to 0 or to the max for each axis,, anyone have the correct commands so i don't have to keep changing the config at least till i have them all figured out. Thanks gary On Saturday, January 6, 2018 at 8:42:16 PM UTC-5, gary wrote: > I just connected a BBB and Cramps board to my delta printer, but i have > been having homing problem > I have optic switches installed if i go into the hal configuration when > machinekit it booted, and then to the show window with xmax ymax and zmax > displayed then when axis's are off the switches there red, and when i > trigger the switches they turn yellow > So i assume the switches are working and being read by the software. > > But when i do home all the motors they move up to the switches in the > correct direction but never stop just keeps running into the optic > end stops and i have to power down.. > > any suggestions? > > Thanks gary > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
