> On 7 Jan 2018, at 23:19, gary <[email protected]> wrote: > > I set home_sequence to 0 1 2 and the search_vel to 3.5 and latch to 1 then > ran the halmeter runs real slow like real real slow even at the old settings > it was running real slow don't think it was going anywhere fast enough to run > right though the stops i could sit there and wait a few seconds for it to run > though the stops and go from false to true and still be able to kill it > before ramming into the stops. > > tried X it didn't home X, it Homed the Z axis and stayed false on the > halmeter for max X limit of course the axis never moved > tried Y it didn't home Y, it Homed the Z axis and stayed false on the > halmeter for max Y limit of course the axis never moved > tried Z it homed Z, it Homed the Z axis and turned to True but keep going > thought the switch till it turned false again on the halmeter for max Z > limit and event though it turned true it didn't stop homing > So for some reason when i home one axis it only moves the Z no matter what > axis is checked. but the dro changes for the correct axis > when i have home_sequence set to 0 0 0 and home all then all 3 will move but > don't stop on True trigged > > For Bas De Bruijn > I can't use the same pins my original pins were setup for the bebopr board.. > if I'm not mistaken cramps pin numbers are different.
Good, that was my idea. Not forgetting to use the CRAMPS pins instead of the bebopr pins. > Thanks gary > >> On Saturday, January 6, 2018 at 8:42:16 PM UTC-5, gary wrote: >> I just connected a BBB and Cramps board to my delta printer, but i have been >> having homing problem >> I have optic switches installed if i go into the hal configuration when >> machinekit it booted, and then to the show window with xmax ymax and zmax >> displayed then when axis's are off the switches there red, and when i >> trigger the switches they turn >> So i assume the switches are working and being read by the software. >> >> But when i do home all the motors they move up to the switches in the >> correct direction but never stop just keeps running into the optic end stops >> and i have to power down.. >> >> any suggestions? >> >> Thanks gary > > -- > website: http://www.machinekit.io blog: http://blog.machinekit.io github: > https://github.com/machinekit > --- > You received this message because you are subscribed to the Google Groups > "Machinekit" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > Visit this group at https://groups.google.com/group/machinekit. > For more options, visit https://groups.google.com/d/optout. -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
