On Sun Nov 9, 2025 at 10:39 AM CET, David Heidelberg via B4 Relay wrote: > From: David Heidelberg <[email protected]> > > C-PHY mode is now supported, so the endpoint bus-type restriction to > D-PHY can be removed. > > Signed-off-by: David Heidelberg <[email protected]> > --- > drivers/media/platform/qcom/camss/camss.c | 9 --------- > 1 file changed, 9 deletions(-) > > diff --git a/drivers/media/platform/qcom/camss/camss.c > b/drivers/media/platform/qcom/camss/camss.c > index 248aa6b21b5ad..1408e8a03f0bd 100644 > --- a/drivers/media/platform/qcom/camss/camss.c > +++ b/drivers/media/platform/qcom/camss/camss.c > @@ -4044,15 +4044,6 @@ static int camss_of_parse_endpoint_node(struct device > *dev, > if (ret) > return ret; > > - /* > - * Most SoCs support both D-PHY and C-PHY standards, but currently only > - * D-PHY is supported in the driver. > - */ > - if (vep.bus_type != V4L2_MBUS_CSI2_DPHY) {
How about just adding && != V4L2_MBUS_CSI2_CPHY to it? Good to check in any case imo. Regards Luca > - dev_err(dev, "Unsupported bus type %d\n", vep.bus_type); > - return -EINVAL; > - } > - > csd->interface.csiphy_id = vep.base.port; > > mipi_csi2 = &vep.bus.mipi_csi2;
