That worked! Thank you so much!
Sent from my iPhone > On 17-Apr-2018, at 7:43 PM, Alvaro Prieto <[email protected]> wrote: > > Aditya, > > Have you tried disabling the DCDC (if you don't have the DC DC inductors)? > > MCU_DCDC_ENABLED: 0 > > I've had problems like these that were caused by that. > > Cheers, > > Alvaro > >> On Tue, Apr 17, 2018 at 7:09 AM, Aditya Xavier <[email protected]> wrote: >> >> Sorry for spamming you all. >> >> However found one curious issue. >> >> Apache is able to boot and start Blinky, if I do Connect (Target -> >> Connect) from Segger. >> >> The moment I disconnect from Segger i.e (Target -> Disconnect ), apache >> doesn’t work anymore. >> >> >> Thanks, >> Aditya Xavier. >> >> >>> On 17-Apr-2018, at 6:19 PM, Aditya Xavier <[email protected]> wrote: >>> >>> Some more information for sake of clarity. >>> >>> I used the nrf52dk in apache, nrf52_pca10040 in zephyr and pca10040 in >> Nordic SDK. >>> >>> Hardware wise its very similar to nrf52dk without the Programmer part. >>> >>> Thanks, >>> Aditya Xavier. >>> >>>> On 17-Apr-2018, at 4:05 PM, Aditya Xavier <[email protected]> wrote: >>>> >>>> Just tested Zephyr SDK Blinky too. >>>> >>>> It works similar to the Nordic SDK, so now its only Mynewt SDK which is >> not booting. >>>> >>>> Do I need to make any changes to BSP ? >>>> >>>> How do I figure out where the problem is ? >>>> >>>> Thanks, >>>> Aditya Xavier. >>>> >>>> >>>>> On 17-Apr-2018, at 1:18 PM, Aditya Xavier <[email protected]> wrote: >>>>> >>>>> Hi Team, >>>>> >>>>> Am stuck at trying to install Blinky firmware on a custom nRF52832 >> board (not using any peripherals apart from 1 GPIO (LED_1)). >>>>> >>>>> The sequence of events which am doing and the results are as follows. >>>>> >>>>> 1. Connect Segger and Erase Device. >>>>> 2. Load nrf52_boot >>>>> 3. Load nrf52_blinky >>>>> 4. nRF starts blinking the LED. >>>>> 5. Restart ( remove power and reconnect power ) >>>>> 6. nRF is no longer blinking the LED. >>>>> >>>>> 1. Connect Segger and Erase Device >>>>> 2. Load nRF SDK Blinky >>>>> 3. nRF starts blinking the LED >>>>> 4. Restart ( remove power and reconnect power ) >>>>> 5. nRF starts blinking the LED. >>>>> >>>>> Am I missing something? >>>>> >>>>> Thanks, >>>>> Aditya Xavier. >>>> >>> >> >>
