Sorry for spamming you all. However found one curious issue.
Apache is able to boot and start Blinky, if I do Connect (Target -> Connect) from Segger. The moment I disconnect from Segger i.e (Target -> Disconnect ), apache doesn’t work anymore. Thanks, Aditya Xavier. > On 17-Apr-2018, at 6:19 PM, Aditya Xavier <[email protected]> wrote: > > Some more information for sake of clarity. > > I used the nrf52dk in apache, nrf52_pca10040 in zephyr and pca10040 in Nordic > SDK. > > Hardware wise its very similar to nrf52dk without the Programmer part. > > Thanks, > Aditya Xavier. > >> On 17-Apr-2018, at 4:05 PM, Aditya Xavier <[email protected]> wrote: >> >> Just tested Zephyr SDK Blinky too. >> >> It works similar to the Nordic SDK, so now its only Mynewt SDK which is not >> booting. >> >> Do I need to make any changes to BSP ? >> >> How do I figure out where the problem is ? >> >> Thanks, >> Aditya Xavier. >> >> >>> On 17-Apr-2018, at 1:18 PM, Aditya Xavier <[email protected]> wrote: >>> >>> Hi Team, >>> >>> Am stuck at trying to install Blinky firmware on a custom nRF52832 board >>> (not using any peripherals apart from 1 GPIO (LED_1)). >>> >>> The sequence of events which am doing and the results are as follows. >>> >>> 1. Connect Segger and Erase Device. >>> 2. Load nrf52_boot >>> 3. Load nrf52_blinky >>> 4. nRF starts blinking the LED. >>> 5. Restart ( remove power and reconnect power ) >>> 6. nRF is no longer blinking the LED. >>> >>> 1. Connect Segger and Erase Device >>> 2. Load nRF SDK Blinky >>> 3. nRF starts blinking the LED >>> 4. Restart ( remove power and reconnect power ) >>> 5. nRF starts blinking the LED. >>> >>> Am I missing something? >>> >>> Thanks, >>> Aditya Xavier. >> >
