Some more information for sake of clarity. I used the nrf52dk in apache, nrf52_pca10040 in zephyr and pca10040 in Nordic SDK.
Hardware wise its very similar to nrf52dk without the Programmer part. Thanks, Aditya Xavier. > On 17-Apr-2018, at 4:05 PM, Aditya Xavier <[email protected]> wrote: > > Just tested Zephyr SDK Blinky too. > > It works similar to the Nordic SDK, so now its only Mynewt SDK which is not > booting. > > Do I need to make any changes to BSP ? > > How do I figure out where the problem is ? > > Thanks, > Aditya Xavier. > > >> On 17-Apr-2018, at 1:18 PM, Aditya Xavier <[email protected]> wrote: >> >> Hi Team, >> >> Am stuck at trying to install Blinky firmware on a custom nRF52832 board >> (not using any peripherals apart from 1 GPIO (LED_1)). >> >> The sequence of events which am doing and the results are as follows. >> >> 1. Connect Segger and Erase Device. >> 2. Load nrf52_boot >> 3. Load nrf52_blinky >> 4. nRF starts blinking the LED. >> 5. Restart ( remove power and reconnect power ) >> 6. nRF is no longer blinking the LED. >> >> 1. Connect Segger and Erase Device >> 2. Load nRF SDK Blinky >> 3. nRF starts blinking the LED >> 4. Restart ( remove power and reconnect power ) >> 5. nRF starts blinking the LED. >> >> Am I missing something? >> >> Thanks, >> Aditya Xavier. >
