> I upgraded my kernel from 2.2.20 to 2.4.20. The system used to boot up > cleanly with 2.2.20. However after upgarding, it does not configure the > NIC card. I have sis900 on my system. The dmesg and ifconfig outputs are > reproduced here: Please help. I am almost losing my nerve! > ********* > dmesg > > Linux version 2.4.20 ([EMAIL PROTECTED]) (gcc version 2.95.4 20011002 (Debian > prerelease)) #1 Sun Aug 24 00:37:24 EDT 2003 > BIOS-provided physical RAM map: > BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) > BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) > BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) > BIOS-e820: 0000000000100000 - 000000000fff0000 (usable) > BIOS-e820: 000000000fff0000 - 000000000fff8000 (ACPI data) > BIOS-e820: 000000000fff8000 - 0000000010000000 (ACPI NVS) > BIOS-e820: 00000000fec00000 - 00000000fec01000 (reserved) > BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved) > BIOS-e820: 00000000ffee0000 - 00000000fff00000 (reserved) > BIOS-e820: 00000000fffc0000 - 0000000100000000 (reserved) > 255MB LOWMEM available. > On node 0 totalpages: 65520 > zone(0): 4096 pages. > zone(1): 61424 pages. > zone(2): 0 pages. > Kernel command line: auto BOOT_IMAGE=Linux ro root=1601 > Initializing CPU#0 > Detected 995.776 MHz processor. > Console: colour VGA+ 80x25 > Calibrating delay loop... 1985.74 BogoMIPS > Memory: 256688k/262080k available (1322k kernel code, 5004k reserved, > 538k data, 100k init, 0k highmem) > Dentry cache hash table entries: 32768 (order: 6, 262144 bytes) > Inode cache hash table entries: 16384 (order: 5, 131072 bytes) > Mount-cache hash table entries: 4096 (order: 3, 32768 bytes) > Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes) > Page-cache hash table entries: 65536 (order: 6, 262144 bytes) > CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) > CPU: L2 Cache: 256K (64 bytes/line) > Intel machine check architecture supported. > Intel machine check reporting enabled on CPU#0. > CPU: After generic, caps: 0383f9ff c1cbf9ff 00000000 00000000 > CPU: Common caps: 0383f9ff c1cbf9ff 00000000 00000000 > CPU: AMD Athlon(tm) Processor stepping 02 > Enabling fast FPU save and restore... done. > Enabling unmasked SIMD FPU exception support... done. > Checking 'hlt' instruction... OK. > POSIX conformance testing by UNIFIX > PCI: PCI BIOS revision 2.10 entry at 0xfdb01, last bus=1 > PCI: Using configuration type 1 > PCI: Probing PCI hardware > PCI: Using IRQ router SIS [1039/0008] at 00:02.0 > isapnp: Scanning for PnP cards... > isapnp: No Plug & Play device found > Linux NET4.0 for Linux 2.4 > Based upon Swansea University Computer Society NET3.039 > Initializing RT netlink socket > Starting kswapd > Journalled Block Device driver loaded > Installing knfsd (copyright (C) 1996 [EMAIL PROTECTED]). > parport0: PC-style at 0x378 [PCSPP(,...)] > pty: 256 Unix98 ptys configured > Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ > SERIAL_PCI ISAPNP enabled > ttyS00 at 0x03f8 (irq = 4) is a 16550A > ttyS01 at 0x02f8 (irq = 3) is a 16550A > Uniform Multi-Platform E-IDE driver Revision: 6.31 > ide: Assuming 33MHz system bus speed for PIO modes; override with > idebus=xx > SIS5513: IDE controller on PCI bus 00 dev 15 > SIS5513: detected chipset, but driver not compiled in! > SIS5513: chipset revision 208 > SIS5513: not 100% native mode: will probe irqs later > ide0: BM-DMA at 0xff00-0xff07, BIOS settings: hda:DMA, hdb:DMA > ide1: BM-DMA at 0xff08-0xff0f, BIOS settings: hdc:DMA, hdd:DMA > hda: LITE-ON LTR-32123S, ATAPI CD/DVD-ROM drive > hdb: TOSHIBA CD-ROM XM-6202B, ATAPI CD/DVD-ROM drive > hdc: WDC WD200EB-00CSF0, ATA DISK drive > hdd: Maxtor 90432D3, ATA DISK drive > ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 > ide1 at 0x170-0x177,0x376 on irq 15 > hdc: 39102336 sectors (20020 MB) w/2048KiB Cache, CHS=38792/16/63 > hdd: 8440992 sectors (4322 MB) w/256KiB Cache, CHS=8374/16/63 > Partition check: > hdc: [PTBL] [2434/255/63] hdc1 hdc2 hdc3 < hdc5 hdc6 hdc7 hdc4 > hdd: [PTBL] [525/255/63] hdd1 < hdd5 > Floppy drive(s): fd0 is 1.44M > FDC 0 is a post-1991 82077 > Linux agpgart interface v0.99 (c) Jeff Hartmann > agpgart: Maximum main memory to use for agp memory: 203M > agpgart: Detected SiS 735 chipset > agpgart: AGP aperture is 64M @ 0xd0000000 > SCSI subsystem driver Revision: 1.00 > scsi0 : SCSI host adapter emulation for IDE ATAPI devices > Vendor: LITE-ON Model: LTR-32123S Rev: XS0R > Type: CD-ROM ANSI SCSI revision: 02 > Vendor: TOSHIBA Model: CD-ROM XM-6202B Rev: 1108 > Type: CD-ROM ANSI SCSI revision: 02 > Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0 > Attached scsi CD-ROM sr1 at scsi0, channel 0, id 1, lun 0 > sr0: scsi3-mmc drive: 40x/40x writer cd/rw xa/form2 cdda tray > Uniform CD-ROM driver Revision: 3.12 > sr1: scsi3-mmc drive: 32x/32x cd/rw xa/form2 cdda tray > Linux Kernel Card Services 3.1.22 > options: [pci] [cardbus] [pm] > usb.c: registered new driver hub > uhci.c: USB Universal Host Controller Interface driver v1.1 > usb.c: registered new driver usbscanner > scanner.c: 0.4.6:USB Scanner Driver > usb.c: registered new driver usblp > printer.c: v0.11: USB Printer Device Class driver > NET4: Linux TCP/IP 1.0 for NET4.0 > IP Protocols: ICMP, UDP, TCP, IGMP > IP: routing cache hash table of 2048 buckets, 16Kbytes > TCP: Hash tables configured (established 16384 bind 16384) > NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. > ds: no socket drivers loaded! > VFS: Mounted root (ext2 filesystem) readonly. > Freeing unused kernel memory: 100k freed > Adding Swap: 497972k swap-space (priority -1) > sis900.c: v1.08.06 9/24/2002 > PCI: Assigned IRQ 11 for device 00:03.0 > eth0: Realtek RTL8201 PHY transceiver found at address 1. > eth0: Using transceiver found at address 1 as default > eth0: SiS 900 PCI Fast Ethernet at 0xd400, IRQ 11, 00:d0:09:fe:58:6e. > [drm] AGP 0.99 on SiS @ 0xd0000000 64MB > [drm] Initialized r128 2.2.0 20010917 on minor 0 > eth0: Media Link On 100mbps full-duplex > > ******** > eth0 Link encap:Ethernet HWaddr 00:D0:09:FE:58:6E > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:125 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:100 > RX bytes:15777 (15.4 KiB) TX bytes:0 (0.0 b) > Interrupt:11 Base address:0xd400 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:24 errors:0 dropped:0 overruns:0 frame:0 > TX packets:24 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:1648 (1.6 KiB) TX bytes:1648 (1.6 KiB) > >
-- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
