Is this a card with two network ports? Unless I'm mistaken, "10BaseT" refers to the RJ-45 (telephone-like) port, while the BNC port should be called "10Base2" or something. You need to change the port using either switch settings on the card, or a software utility that came with the card. My memory on this is a little fuzzy, so I hope I'm not full of crap.
Marc ---------- Marc Mongeon <[EMAIL PROTECTED]> Unix Specialist Ban-Koe Systems 9100 W Bloomington Fwy Bloomington, MN 55431-2200 (612)888-0123, x417 | FAX: (612)888-3344 ---------- "It's such a fine line between clever and stupid." -- David St. Hubbins and Nigel Tufnel of "Spinal Tap" >>> "Alex V. Toropov" <[EMAIL PROTECTED]> 08/19 4:02 AM >>> > Yes - the windows-machines can see each other in the windows-network. > (Workgroupname Olsen as the domainname at the linux box.) > The windows pc's can ping each other, but not the linux. > > I'm using bnc-cables, and the linux is in the middle. I've tried to change > the T's - no effect. > The start-up messages show no problems initializing the network-card. (Loading > modules ..... vfat smbfs 3c509 at 0x300 tag 1, 10baseT port, address 00 60 08 > 31 22 84, IRQ 10) > (eth0: Setting Rx mode to 1 addresses) > > Yours Henning Well, one logical thing to test - try "route -n" You should see line like 192.168.1.0 0.0.0.0 255.255.255.0 ............ eth0 If it exists then I can't see any logical errors and I think the problem is in NIC may be You can change cards between computers and see if linux card will work in PC and vise verse. -- Unsubscribe? mail -s unsubscribe [EMAIL PROTECTED] < /dev/null
