On Tuesday 03 August 2004 06:05 pm, John Summerfield wrote: > Please, don't crosspost lists and newsgroups: it's bad enough having my > email address in Debian archives without having it in newgroups too. > > Had I noticed before beginning to reply, <plonk> > > Wolfgang Zocher wrote: > >Hi all, > > > >I have lots of problems getting the HP PSC 1110 running under woody 3.0 r2 > >using kernel 2.4.18-k7. At the very beginning I tried to use hpoj-0.8x > > from stable and the corresponding libusb, printer.o etc. (all from > > stable). But either printing nor scanning worked; hptal-init setup told > > me, that there is a device psc-1110 from vendor HP but there was no way > > to talk to this device. > > > >So I got the latest hpoj sources and the latest libusb sources, installed > > all the stuff - the result is the same. > > > >Then I tried printing with foomatic-rip and hpijs-0.16 and, surprise, it > >works. > > > >My question: is there any body out there who succeeded with installing > > hpoj AND printing AND scanning via ptal with woody r2 2.4.18? Is there a > > chance to get the scanner working without using hpoj? > > Since hpoj is the HP-supported OSS project speficially to support > these devices, I wouldn't expect so. > > Also, were I to acquire one of these HP all-in-one devices (and I have > been considering it), I would most assuredly go straight to Sarge. > > According to email I got from HP recently, this project supports all > current and near-future devices BUT woody is just too ancient. > > > > -- > > Cheers > John > > -- spambait > [EMAIL PROTECTED] [EMAIL PROTECTED] > Tourist pics http://portgeographe.environmentaldisasters.cds.merseine.nu/
I agree with John, I have an HP PSC-2110 and it works very well in sarge. hpoj is a must have. Good luck, -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
