Had I noticed before beginning to reply, <plonk>
Wolfgang Zocher wrote:
Hi all,
I have lots of problems getting the HP PSC 1110 running under woody 3.0 r2 using kernel 2.4.18-k7. At the very beginning I tried to use hpoj-0.8x from stable and the corresponding libusb, printer.o etc. (all from stable). But either printing nor scanning worked; hptal-init setup told me, that there is a device psc-1110 from vendor HP but there was no way to talk to this device.
So I got the latest hpoj sources and the latest libusb sources, installed all the stuff - the result is the same.
Then I tried printing with foomatic-rip and hpijs-0.16 and, surprise, it
works.
My question: is there any body out there who succeeded with installing hpoj AND
printing AND scanning via ptal with woody r2 2.4.18? Is there a chance to get
the scanner working without using hpoj?
Since hpoj is the HP-supported OSS project speficially to support these devices, I wouldn't expect so.
Also, were I to acquire one of these HP all-in-one devices (and I have been considering it), I would most assuredly go straight to Sarge.
According to email I got from HP recently, this project supports all current and near-future devices BUT woody is just too ancient.
--
Cheers John
-- spambait [EMAIL PROTECTED] [EMAIL PROTECTED] Tourist pics http://portgeographe.environmentaldisasters.cds.merseine.nu/
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
