Package: installation-reports
Boot method: <How did you boot the installer? CD? floppy? network?>
Image version: <Full URL to image you downloaded is best>
Date: <Date and time of the install>
Machine: <Description of machine (eg, IBM Thinkpad R32)>
Processor:
Memory:
Partitions: <df -Tl will do; the raw partition table is preferred>
Output of lspci -nn and lspci -vnn:
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [O]
Detect network card: [O]
Configure network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Install base system: [O]
Clock/timezone setup: [O]
User/password setup: [O]
Install tasks: [O]
Install boot loader: [O]
Overall install: [E]
Comments/Problems:
<Description of the install, in prose, and any thoughts, comments
and ideas you had during the initial install.>
All the installation from Debian/PowerPC_Etch net-inst seemed to work fine
over my ethernet connection to cable modem. I installed to separate HDD for Etch only.
Re-partition proceded ok. However on reboot I never get a video interface.
The video terminal goes black after boot up. The system seems to remain live, just no video signal.
I have my monitor on the analog connector to the video card.
stephen-dills-power-mac-g5:~ sdill$ lspci -nn
-bash: lspci: command not found
stephen-dills-power-mac-g5:~ sdill$ lspci -vnn
-bash: lspci: command not found
I chose the "typical" partition format since I don't have the skill set to make
any different decision.
I was taking notes on my install and I'm fairly certain my download file was
located at: http://saimei.acc.umu.se.
MD5 as correct, (/Users/sdill/Desktop/Internet
Download/debian-40r0-powerpc-netinst.iso) = 15fd2132871e7be159efaf54871968f0
Here's a snapshot of my system:
Machine Name: Power Mac G5
Machine Model: PowerMac7,3
CPU Type: PowerPC G5 (3.0)
Number Of CPUs: 2
CPU Speed: 1.8 GHz
L2 Cache (per CPU): 512 KB
Memory: 1.5 GB
Bus Speed: 900 MHz
Boot ROM Version: 5.1.8f7
ATI Radeon X800 XT:
Chipset Model: ATY,R420
Type: Display
Bus: AGP
Slot: SLOT-1
VRAM (Total): 256 MB
Vendor: ATI (0x1002)
Device ID: 0x4a48
Revision ID: 0x0000
ROM Revision: 113-A35801-108
Displays:
EN7220:
Resolution: 1280 x 1024 @ 75 Hz
Depth: 32-bit Color
Core Image: Supported
Main Display: Yes
Mirror: Off
Online: Yes
Quartz Extreme: Supported
Display:
Status: No display connected
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
