This is your clue... Do exactly what it says...
At a guess, I'd say you've loaded the wcfxs module before wcfxo. This
will push your existing X100P interfaces out to channels 3 and 4. Either
change your zaptel.conf to suit, or load wcfxo prior to wcfxs to have your
FXO cards appear where they used to.
That's the problem, i've tried that. I swapped them around so that the X100P's are channel 3-4 and the TDM400P is channel 1-2, but the same thing:
ZT_CHANCONFIG failed on channel 1: Invalid argument (22) Did you forget that FXS interfaces are configured with FXO signalling and that FXO interfaces use FXS signalling?
When I startup zaptel it loads as follows:
Loading zaptel hardware modules: wcfxo wcfxs wcusb
I can't figure it out....
-- jeremy bogan [ [EMAIL PROTECTED] ] segment publishing - design.develop.host
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
