From: Tomas Alvarez Vanoli <[email protected]> Move the call to configure the qrio i2c deblock pins earlier. Before this, the call was happening after the first attempt to deblock the SDP EEPROM, which resulted in a not correct sequence.
Signed-off-by: Tomas Alvarez Vanoli <[email protected]> Signed-off-by: Holger Brunck <[email protected]> --- board/keymile/pg-wcom-ls102xa/pg-wcom-ls102xa.c | 4 +--- 1 file changed, 1 insertion(+), 3 deletions(-) diff --git a/board/keymile/pg-wcom-ls102xa/pg-wcom-ls102xa.c b/board/keymile/pg-wcom-ls102xa/pg-wcom-ls102xa.c index 409a55ebda6..7db75f4df3e 100644 --- a/board/keymile/pg-wcom-ls102xa/pg-wcom-ls102xa.c +++ b/board/keymile/pg-wcom-ls102xa/pg-wcom-ls102xa.c @@ -38,7 +38,7 @@ static uchar ivm_content[CONFIG_SYS_IVM_EEPROM_MAX_LEN]; int checkboard(void) { show_qrio(); - + i2c_deblock_gpio_cfg(); return 0; } @@ -96,8 +96,6 @@ int board_early_init_f(void) qrio_prstcfg(KM_DBG_ETH_RST, PRSTCFG_POWUP_UNIT_CORE_RST); qrio_prst(KM_DBG_ETH_RST, !qrio_get_pgy_pres_pin(), false); - i2c_deblock_gpio_cfg(); - /* enable the Unit LED (red) & Boot LED (on) */ qrio_set_leds(); -- 2.49.0
