The Next button won't work if you haven't configured enough partitions
with proper mount points. Chances are you filled out something wrong in
diskdruid.
First of all, as I read your post you set the disk device as the mount
point; this isn't right. I may be reading incorrectly but the mount
point should be / if you're only going to have one partition. Use the
pull-down menu in the graphical install tool, it has a list of possible
mount points, or just enter "/" in the "mount point" field.
Another possibility is that you haven't configured any swap space, but
if you had 6.2 installed already then the installer should see the swap
space from before and use that.
Jerry Human wrote:
>
> Hello Everyone:
>
> I have just installed RH 7.0 (Respin) and I had a problem getting past
> DiskDruid. I used fdisk to set a Linux partiton on hdb3 and selected it
> for the mount point. However, once this was done (I tried several times)
> the "NEXT" button would not work. "Manually Partition with Fdisk" and
> "Manually Partition with DiskDruid" were both tried with no success.
> Finally, "Auto install" was selected and it did install. BUT, the
> install started at hda4 {620 meg} (which was RH 6.2 for maintanence when
> I have problems with the main install) and continued on hdb1 {2 gig}
> which was setup on Win95 32 bit for win95 files. How can I blow all this
> away and get RH 7.0 to install only on hdb3, a four gig partition for
> RH?
>
> Thank you.
>
> _______________________________________________
> Redhat-list mailing list
> [EMAIL PROTECTED]
> https://listman.redhat.com/mailman/listinfo/redhat-list
--
Michael Jinks, IB // Technical Entity // Saecos Corporation
Opinions expressed above are my own, and not those of my employer.
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
