You could disconnect the cable from eth0.
Your machine will only have one default route...and since it's
usually going to be defaulted to the IP on eth0, unless there is no
connection there.
On Thu, 22 Feb 2001 07:26:33 -0800, David Brenner wrote:
>Dumb dual NIC question.
>
>I have two NICs installed on 6.2 box that is being configured as
>firewall/proxy.
>
>In testing the install and setup I can ping other boxes apparently via eth0,
>how do I force ping to go out on eth1?
>
>The cards are currently set as 192.168.0.1 (eth0) and 192.168.0.99 (eth1).
>both on subnet 255.255.255.0. I have not added any additional card
>properties (irq, etc) in modules.conf or lilo.conf append line.
>
>Where would I look in How-To's to find this info?
>
>Thanks for your help.
>
>David Brenner
>
>
>
>_______________________________________________
>Redhat-list mailing list
>[EMAIL PROTECTED]
>https://listman.redhat.com/mailman/listinfo/redhat-list
>
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
