Hi again,
More problems. I have had to reinstall RH7 from scratch after a
failed upgrade from which I was unable to recover with any of the tools
that I know and my limited knowledge. Now I cannot seem to get either
my SCSI tape unit or my ATAPE CDR going again.
The settings for the kernel recompile
Y Loadable module support CONFIG_MODULES
Y Kernel module loader CONFIG_KMOD
Y Enhanced IDE/MFM/RLL disk
/cdrom/tape/floppy support CONFIG_GLD_DEV:IDE
M Include IDE/ATAPI CDROM Support CONFIG_BLK_DEV_IDECD
N Include IDE/ATAPI TAPE Support CONFIG_BLK_DEV_IDETAPE
Y SCSI Emulation Support CONFIG_BLK_DEV_IDESCSI
M Loopback device support CONFIG_BLK_DEV_LOOP
Y SCSI Support CONFIG_SCSI
M SCSI Disk Support CONFIG_BLK_DEV_SD
Y SCSI Tape Support CONFIG_CHR_DEV_ST
Y SCSI CD-ROM Support CONFIG_BLK_DEV_SR
Y SCSI Generic Support CONFIG_CHR_DEV_SG
After a 'make mrproper' I did a 'make dep clean bzImage' and then a
'make modules' and a 'make modules_install' after moving the former
/lib/modules/(directory) out by renaming it.
Upon booting the following error was noted:
Unresolved dependencies in /lib/modules/2.2.16-22 scsi/sd.mod.o
[Punctuation might not be absolutely correct]
According to the HOW-TO the kernel is set up properly with the
following change. I do not have any ATAPI tape drives and I do have a
SCSI tape (OnStream ADR50) newly installed. I am not sure what to do
with the unresolved dependency issue.
Suggestions?
TIA
Bob, the ever newbie newbie!
--
Bob Hartung
www.radiologygrouppc.com
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
