I am running RH6.2 on a Compaq Deskpro PIII/600 with 128MB Ram and U/W scsi
disk (connected to a DAC960 controller)
I have no problems with the disks, and performance is great. My problems
occur when trying to restore data from an Seagate AIT tape drive (25/50).
The drive is connected to an Adaptec 29160N scsi controller.
Linux is using the AIC7xxxx driver for this device.
Using cpio -i , I get an error messages such as:
"cpio skipped xxxx blocks of junk"
While tar gives me similar errors. I have also tried dump and taper with
similar results. I have tried cleaning the drive, different tape cartridges
etc.
Does anyone have nay ideas on this?
Regards
Enrico Payne
mailto:[EMAIL PROTECTED]
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
