Set the card as an NE2000 compatible..... I have a realtek chip card, but
manufacturers would be different for the actual cards I guess........make
sure its not in pnp mode by setting it with the software to be on a known
IRQ
PS also read my sig :-)
*********** REPLY SEPARATOR ***********
On 6/02/00 at 15:34 serkoon wrote:
Hi,
I try to run RH6.0 with a realtek8139 network card, and of course
networksupport for this card.. But when I try to boot Linux (even after the
first install) many services [FAILED] to start, sometimes RH can't even set
my clock!
Does anybody know why this happens, I've tried RH6.0 without network
support, and then my system seems to run just fine..
Thanks in advance, Pieter
Regards
Greg Wright
IT Consultant Sydney Australia
--
*** Please trim any replies ***
*** Please turn off HTML in your email ***
*** Please don't use the list for test messages ***
*** Why not read the archives? http://moongroup.com/redhat.phtml ***
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
