On Wed, 2 Feb 2000, Raju K V wrote:
> hi,
>
> Everytime during the boot, I get the foll. messages:
>
> eth0: Digital DS21142/3 Tulip at 0x7000, 00 60 67 36 42 52, IRQ 10.
> eth0: EEPROM default media type Autosense.
> eth0: Index #0 - Media 10baseT (#0) described by a 21142 Serial PHY (2)
> block.
> eth0: Index #1 - Media 10baseT-FD (#4) described by a 21142 Serial PHY
> (2) block.
> eth0: Index #2 - Media 100baseTx (#3) described by a 21143 SYM PHY (4)
> block.
> eth0: Index #3 - Media 100baseTx-FD (#5) described by a 21143 SYM PHY
> (4) block.
> eth0: 21140 transmit timed out, status f0260000, SIA 000000c6 ffff0000
> fffbff7f 8ff40008, resetting...
> eth0: transmit timed out, switching to 100baseTx media.
> eth0: 21142 10mpbs sensed media.
> eth0: 21140 transmit timed out, status f0260400, SIA 000000c6 ffff0000
> fffbffff 8ff00008, resetting...
> eth0: transmit timed out, switching to 10baseT media.
> grep uses obsolete /proc/pci interface
>
> Also immediately after boot, I cannot ping any remote machines. I will
> first have to ping localhost and only then can I ping remote host.
>
What version of the tulip driver are you using? I would guess that you
have a card with the newer digital clone, try a newer version of the tulip
driver.
Bill Carlson
------------
Systems Programmer [EMAIL PROTECTED] | Opinions are mine,
Virtual Hospital http://www.vh.org/ | not my employer's.
University of Iowa Hospitals and Clinics |
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
