Stephen,
will compile options did you use?
Regards
Alf
> -----Original Message-----
> From: Stephen Johnston [SMTP:[EMAIL PROTECTED]]
> Sent: 17 November 1999 16:03
> To: [EMAIL PROTECTED]
> Subject: Re: Does the 3c905C TX work with RH 6.0?
>
> Hi
>
> If you use RH6.1 and tell it during install to load an 'Add Device' then
> "Network' and select the Vortex driver it will work - I had problems
> with the TXM incarnation of this card. Alternatively download the most
> up to date 3c59x.c file from Donald Becker's site and dump it in
> /usr/src/linux/drivers/... and recompile the kernel.
>
> Hope this helps.
>
> Regards,
>
> Stephen.
>
> Cedric Marsot wrote:
> >
> > Be very careful with the 3C905C-TX.
> > Normaly (but I have not tested), the chipset on 3C905C is different than
> > 3C905B. So modules must be different.
> >
> > --
> > cedric
> >
> > > -----Original Message-----
> > > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
> > > Sent: Wednesday, November 17, 1999 4:26 PM
> > > To: [EMAIL PROTECTED]
> > > Subject: Re: Does the 3c905C TX work with RH 6.0?
> > >
> > >
> > >
> > >
> > > not sure, but with 3c509b, had to turn off PNP on the NIC
> > > using 3c5x9cfg,
> > > then re-install rh 6.1. maybe that helps.
> > >
> > >
> > >
> > > "Jeff Hogg" <[EMAIL PROTECTED]> on 11/15/99 09:38:00 AM
> > >
> > > Please respond to [EMAIL PROTECTED]
> > >
> > > To: "redhat" <[EMAIL PROTECTED]>
> > > cc:
> > > Subject: Does the 3c905C TX work with RH 6.0?
> > >
> > >
> > >
> > > I recently purchased a 3com Ethernet card 10/100 that uses
> > > the 3c905C TX
> > > chipset. Has anyone made use of this type of card? I attempted to
> > > modprobe
> > > 3c95x to set it up and all it gave me in response was device
> > > or resource
> > > busy... I tried setting it up via linuxconf and manually.
> > > /proc/pci sees
> > > it and knows it is set to use irq 10, which is open according to
> > > /proc/interrupts. Any advice?
> > >
> > > Jeff Hogg
> > >
> > >
> > > --
> > > To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
> > > as the Subject.
> > >
> > >
> > >
> > >
> > >
> > > --
> > > To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
> > > as the Subject.
> > >
> > >
> >
> > --
> > To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
> > as the Subject.
>
> --
> Stephen Johnston Phone: +49 89 32006760
> UNIX Administrator Fax : +49 89 32006380
> European Southern Observatory
> Karl-Schwarzschild-Strasse 2
> D-85748 Garching bei Muenchen http://www.eso.org
>
>
> --
> To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
> as the Subject.
**********************************************
The information contained in this e-mail may be privileged and/or confidential.
If you are not the intended recipient, use of this information (including disclosure,
copying or distribution) may be unlawful therefore please inform the sender and delete
the message immediately. The views expressed in this e-mail are not necessarily
those held by Computershare Services PLC and Computershare Services PLC does not accept
liability for any action taken in reliance on the contents of this message (other than
where the company has a legal or regulatory obligation to do so) or for the
consequences
of any computer viruses which may have been transmitted by this e-mail.
Computershare Services PLC
Registered in England & Wales (No. 3498808)
Registered Office:- 7th Floor, Jupiter House, Triton Court, 14 Finsbury Square,
London, EC2A 1BR
Regulated by IMRO
***********************************************
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
