Be very careful with the 3C905C-TX.
Normaly (but I have not tested), the chipset on 3C905C is different than
3C905B. So modules must be different.
--
cedric
> -----Original Message-----
> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
> Sent: Wednesday, November 17, 1999 4:26 PM
> To: [EMAIL PROTECTED]
> Subject: Re: Does the 3c905C TX work with RH 6.0?
>
>
>
>
> not sure, but with 3c509b, had to turn off PNP on the NIC
> using 3c5x9cfg,
> then re-install rh 6.1. maybe that helps.
>
>
>
> "Jeff Hogg" <[EMAIL PROTECTED]> on 11/15/99 09:38:00 AM
>
> Please respond to [EMAIL PROTECTED]
>
> To: "redhat" <[EMAIL PROTECTED]>
> cc:
> Subject: Does the 3c905C TX work with RH 6.0?
>
>
>
> I recently purchased a 3com Ethernet card 10/100 that uses
> the 3c905C TX
> chipset. Has anyone made use of this type of card? I attempted to
> modprobe
> 3c95x to set it up and all it gave me in response was device
> or resource
> busy... I tried setting it up via linuxconf and manually.
> /proc/pci sees
> it and knows it is set to use irq 10, which is open according to
> /proc/interrupts. Any advice?
>
> Jeff Hogg
>
>
> --
> To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
> as the Subject.
>
>
>
>
>
> --
> To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
> as the Subject.
>
>
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
