>>On Thu, 2002-12-26 at 20:32, Peter Davie wrote: >> >> >>>"eth0 has an alias to module eepro100 in modules.conf, instead of >>>currently loaded module CDC Ethernet Class! <OK>" >>>
>Peter Davie wrote:
Ah, don't say that... Most Systems Administration is just knowing lot'sBen, Thanks for your reply. After getting the CD-ROM replaced, I've done a clean install (formatted all except /home). Still the problem persists. The lsmod shows eepro100 installed but no CDC anything. I'm afraid I don't see any answers here, clearly it takes more skill than I have to solve this.
of arcane facts.
I looked at your config files and I don't see any problems.
I've had a problem with RedHat 8.0 on several machines where the network
interfaces are detected and the modules are loaded and the config files
are all in place, but for some unknown reason, during the install they
are in a "de-activated" state.
Can you look in /etc/sysconfig/hwconf and find the paragraph of lines about your network cards. See if there is anything there about "detached" or "deactivated" or "disabled".
If so write back. I don't remember exactly what I did to fix the problem, but I think that I copied /etc/sysconfig/hwconf to /etc/sysconfig/hwconf.install and then deleted /etc/sysconfig/hwconf and
reran kudzu and followed it's prompts, then I ran "neat" (in X-windows)
and made sure that all the options were set reasonably. (Activate on boot comes to mind).
Don't give up, and write back to the list, somebody else may have better
help.
Happy New Year! :)
--
redhat-list mailing list
unsubscribe mailto:[EMAIL PROTECTED]?subject=unsubscribe
https://listman.redhat.com/mailman/listinfo/redhat-list
