> >From what you are saying, this is the picture I am getting of your SCSI
> system:
>
> <CTRL> -68pin- <ID3> -68pin- <ID2or0> -68pin- <ID0or2> -68pin- <ID1>
This is the layout. There are two internal sockets on the 875 controller. ID's
0 and 1 are terminated as each is on a separate cable. ID0 is a 68 pin drive
but it's on a 50 pin cable and so has an adapter.
<CTRL> -68pin- <ID3> -68pin- <ID2> -68pin- <ID1>
<CTRL> -50pin- <ID0>
> Where ID's 0 and 1 are both terminated (with ID 1 also on a 68-50pin
> adapter). If this is the correct layout, you need to disable termination on
> the Quantum drive (the bus should only be terminated at the end of the
> cables).
Thanks but this wasn't the cause of the problem.
The cause of the problem was that I had set the sync rate for the IBM drives
too high. This has been corrected.
--
Eze Ogwuma
--
PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips /mailing-lists
To unsubscribe: mail [EMAIL PROTECTED] with
"unsubscribe" as the Subject.
