Barry, wasn't supposed to be a second hole in the 8-16 MC cam thru which the index mark for the 16-32 MC one can be seen ? The 8-16 MC cam should be aligned first ! As far as I remember, there is no clamp that can be loosen on the 8-16 MC cam shaft to adjust the cam position. It should be aligned by rotation of the KC knob, then the proper 000 KC reading of the counter can be adjusted and then all the other cam positions in the order specified in the chapter 73 of the TM11-5820-357-35. Be sure to apply the procedure of the chapter 73 (page 88) from the very beginning !
73, Jacques, VE2JFE in Montreal In the R-390, I notice that for the 16-32 MC CAM, when the others are in alignment and the lines can be seen through the holes for those, the line for this cam is hidden by the 8-16 MC CAM underneath it. I don't see how that could be visible and presume it's normal but wondering how one is supposed to align the 16-32 MC CAM properly. Thanks, Barry - N4BUQ ______________________________________________________________ R-390 mailing list Home: http://mailman.qth.net/mailman/listinfo/r-390 Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
