As such there is no restriction on when to check for provisioning although I have selected option of checking after registration of device.
On Fri, Feb 26, 2021, 22:11 Ludovic Zammit <[email protected]> wrote: > Provisioner workflow are triggered by DHCP traffic seen from the > Production or Registration networks. > > When do you want to check if Symantec is installed ? > > Thanks, > > > Ludovic Zammit > [email protected] :: +1.514.447.4918 (x145) :: www.inverse.ca > Inverse inc. :: Leaders behind SOGo (http://www.sogo.nu) and PacketFence > (http://packetfence.org) > > > > > > > > > On Feb 26, 2021, at 11:40 AM, NITISH AGGARWAL <[email protected]> > wrote: > > Yes....as I connects the device it went into registration vlan and then if > it is in domain it gets authenticated and vlan changes as per switch. > > Dot1x is working fine...but problem is with Symantec. How to check if end > device has Symantec client installed and working. > > On Fri, Feb 26, 2021, 22:07 Ludovic Zammit <[email protected]> wrote: > >> Hello, >> >> Your devices that connect on PF are statically IP addressed? >> >> Thanks, >> >> >> Ludovic Zammit >> [email protected] :: +1.514.447.4918 (x145) :: www.inverse.ca >> Inverse inc. :: Leaders behind SOGo (http://www.sogo.nu) and PacketFence >> (http://packetfence.org) >> >> >> >> >> >> >> >> >> On Feb 25, 2021, at 9:55 AM, NITISH AGGARWAL via PacketFence-users < >> [email protected]> wrote: >> >> Hi, >> >> I have setup PacketFence zen as per guide. I can see dot1x authentication >> working with MSCHAPv2 auth, so non domain users are not getting access, >> which is required. I am using auto-registration in connection profile. >> >> Second, I have to check for Symantec in my endpoints. I have setup SEPM >> provisioning as per document. During authentication, I can see security >> event generated for provisioning on my node in PacketFence but my end >> device got access to intranet no matter symantec installed on it or not. >> >> I have tried everything I could. I need some help in this case. I am >> using static ips and cisco 2960. >> >> I need devices to be registered if they have both domain connected and >> SEPM installed. >> >> Any help will be appreciated. Thanks in advance... >> >> >> _______________________________________________ >> PacketFence-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/packetfence-users >> >> >> >
_______________________________________________ PacketFence-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/packetfence-users
