Hi Tom, thanks so much for your kind answer.. I did a fresh install and now everything works well
On Mon, Jul 8, 2019 at 11:30 PM Tom Esker via PacketFence-users < [email protected]> wrote: > Chadwick, > > > > Can you access the PF VM from VMWare console and restart networking or the > entire server? > > > > Maybe that’s all that’s needed. Think that’s what I did last week when I > was last working on this. > > > > I’m just one step ahead of you but *am* getting output on the radius > audit page – but with no reason given for auth status “reject.” > > > > Anyway, hope that helps. Good luck. > > > > > > *From:* Chadwick Boseman via PacketFence-users < > [email protected]> > *Sent:* Wednesday, July 3, 2019 9:52 PM > *To:* [email protected] > *Cc:* Chadwick Boseman <[email protected]> > *Subject:* [PacketFence-users] Packetfence ZEN bridge problem > > > > Hi, > > so I've deployed my Packetfence ZEN on VMware, i've followed the > documentation : > > > > > https://packetfence.org/doc/PacketFence_Installation_Guide.html#_going_through_the_configurator > > > > and I've reach the testing part > 5.7. Testing > <https://packetfence.org/doc/PacketFence_Installation_Guide.html#_testing> > > If I'm correct, > > 1) by default ZEN is configured to use NAT on VM (The first time I open > the .ova, the network configuration was set to NAT), > > 2) by default the IP address of the eth0 interface is set to a static > address > > > > When I try to connect a client (a Windows 10 laptop) to my 2960 switch, > the authentication prompt popped up, I entered both valid and invalid > credentials, but the authentication failed, > > > > the documentation said : > > *"To see what’s going on from PacketFence, click on the Auditing tab from > PacketFence’s admin interface. You should see an entry for the MAC address > of your Microsoft Windows 7 endpoint" * > > > > but when I checked, there was nothing there.. > > My understanding is the switch has no way to communicate with the pf > server in the VM since it is using NAT.. > > > > When I tried to change it to bridged connection to make the PF bridge my > PC's ethernet connection, the IP address of the PF eth0 didn't change, so I > change it to a valid IP address from my LAN segment, and I cannot access > the configurator, or the admin page.. > > > > Can anyone help me please..? maybe I missed something or there is > additional configuration I need for it to work? > > Thanks in advance > > > > > > > > > *CONFIDENTIALITY NOTICE:* > > This electronic mail transmission has been sent by the law firm Wyatt > Early Harris Wheeler LLP. It may contain information that is confidential, > privileged, proprietary, or otherwise legally exempt from disclosure. If > you are not the intended recipient, you are hereby notified that you are > not authorized to read, print, retain, copy, or disseminate this message, > any part of it, or any attachments. If you have received this message in > error, please delete this message and any attachments from your system > without reading the content and notify the sender immediately of the > inadvertent transmission. There is no intent on the part of the sender to > waive any privilege, including attorney-client privilege, that may attach > to this communication. Thank you for your cooperation. > _______________________________________________ > PacketFence-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/packetfence-users >
_______________________________________________ PacketFence-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/packetfence-users
