Hi Arun,
We are still hitting this issue, and this can be seen on stable/oxygen as
well.
In some cases the flow will be programmed initially, but after some time
it disappears.
I do see a lot of "Switch Idle state occurred,
node=/10.30.170.51:60858|auxId=0" messages in the logs. Is that anything to
worry about?
If there is any specific TRACE logs to be enabled while running the CSIT,
could you please let me know? I can run the CSIT with the same and supply the
logs.
Thanks,
Faseela
From: Faseela K
Sent: Tuesday, July 17, 2018 1:24 PM
To: Anil Vishnoi <[email protected]>
Cc: D Arunprakash <[email protected]>; Gobinath .
<[email protected]>; Sam Hague <[email protected]>; Dayavanti Gopal Kamath
<[email protected]>; Jamo Luhrsen <[email protected]>;
Vishal Thapar <[email protected]>; [email protected]
Subject: Netvirt Cluster CSIT : Table Miss Entry programming failing randomly
Anil,
I have raised the below JIRA, where I see Table Miss flow for Table 43 is
sometimes not getting programmed on one of the computes in netvirt 3 node CSIT.
https://jira.opendaylight.org/browse/OPNFLWPLUG-1028
I do see flow being pushed to config/inventory by netvirt, but it is missing on
switch.
This makes the basic DHCP itself fail for netvirt as this is one of the
important flows needed for all broadcasts to work.
Any pointers?
Thanks,
Faseela
_______________________________________________
openflowplugin-dev mailing list
[email protected]
https://lists.opendaylight.org/mailman/listinfo/openflowplugin-dev
