Back when Slackware was a 0.9.6 or so, I set up virtual ethernet connections. So I had eth0, eth0:1 eth0.2 eth0.3 etc. But I can't figure out how I did that. Also need to set different routing for each.
Suggestions on how to do it or where to RTFM (Read The Fine Manual) are appreciated. Situation is I have a network and DHCP on the primary interface, but on the secondary, I would use to access management interface of another device/router on other subnets (on the same physical wire), etc. Anyway that is the concept. Thanks in advance. ... BTW, I am using Linux Mint, a Debian derivative. ><> ... Jack -- -- You received this message because you are subscribed to the Google Groups "NLUG" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/nlug-talk?hl=en --- You received this message because you are subscribed to the Google Groups "NLUG" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
