[net 04/12] net/mlx5e: ethtool, Avoid setting speed to 56GBASE when autoneg off

[Saeed Mahameed]

From: Mohamad Heib <moham...@mellanox.com>

Setting speed to 56GBASE is allowed only with auto-negotiation enabled.

This patch prevent setting speed to 56GBASE when auto-negotiation disabled.

Fixes: f62b8bb8f2d3 ("net/mlx5: Extend mlx5_core to support ConnectX-4 Ethernet 
functionality")
Signed-off-by: Mohamad Heib <moham...@mellanox.com>
Signed-off-by: Saeed Mahameed <sae...@mellanox.com>
---
 drivers/net/ethernet/mellanox/mlx5/core/en_ethtool.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/net/ethernet/mellanox/mlx5/core/en_ethtool.c 
b/drivers/net/ethernet/mellanox/mlx5/core/en_ethtool.c
index ee9fa0c2c8b9..e89dba790a2d 100644
--- a/drivers/net/ethernet/mellanox/mlx5/core/en_ethtool.c
+++ b/drivers/net/ethernet/mellanox/mlx5/core/en_ethtool.c
@@ -1081,6 +1081,14 @@ int mlx5e_ethtool_set_link_ksettings(struct mlx5e_priv 
*priv,
        link_modes = autoneg == AUTONEG_ENABLE ? ethtool2ptys_adver_func(adver) 
:
                mlx5e_port_speed2linkmodes(mdev, speed, !ext);
 
+       if ((link_modes & MLX5E_PROT_MASK(MLX5E_56GBASE_R4)) &&
+           autoneg != AUTONEG_ENABLE) {
+               netdev_err(priv->netdev, "%s: 56G link speed requires autoneg 
enabled\n",
+                          __func__);
+               err = -EINVAL;
+               goto out;
+       }
+
        link_modes = link_modes & eproto.cap;
        if (!link_modes) {
                netdev_err(priv->netdev, "%s: Not supported link mode(s) 
requested",
-- 
2.21.0