Dear Liu, > -----Original Message----- > From: Gabriele Paoloni [mailto:gabriele.paol...@huawei.com] > Sent: Friday, June 03, 2016 6:59 PM > To: liudongdong (C); Izumi, Taku/泉 拓 > Cc: Linuxarm; netdev@vger.kernel.org > Subject: RE: [bug discuss] fjes driver call trace warning, "PNP0C02" used in > fjes seems like a bug, > > Hi Dongdong > > Thanks for flagging this > > +to: Taku Izumi <izumi.t...@jp.fujitsu.com> > > Gab > > > -----Original Message----- > > From: linuxarm-boun...@huawei.com [mailto:linuxarm-boun...@huawei.com] > > On Behalf Of Dongdong Liu > > Sent: 03 June 2016 10:38 > > To: netdev@vger.kernel.org > > Cc: Linuxarm > > Subject: [bug discuss] fjes driver call trace warning, "PNP0C02" used > > in fjes seems like a bug, > > > > Hi all: > > > > The bug is recorded in https://bugs.linaro.org/show_bug.cgi?id=2292. > > > > "PNP0C02" attached two modules drivers/pnp/system.c and > > drivers/net/fjes/fjes_main.c . > > "fjes" driver lead to the call trace. > > > > system.c: > > static const struct pnp_device_id pnp_dev_table[] = { > > /* General ID for reserving resources */ > > {"PNP0c02", 0}, > > /* memory controller */ > > {"PNP0c01", 0}, > > {"", 0} > > }; > > > > jes_main.c: > > static const struct acpi_device_id fjes_acpi_ids[] = { > > {"PNP0C02", 0}, > > {"", 0}, > > }; > > > > Both of the modules use id "PNP0C02" (case insensitive), > > > > I used "PNP0C02" to mark motherboard reserved resource as below in > > UEFI. > > Device (RES1) > > { > > Name (_HID, "HISI0081") // HiSi PCIe RC config baseaddress > > Name (_CID, "PNP0C02") // Motherboard reserved resource > > Name (_CRS, ResourceTemplate (){ > > Memory32Fixed (ReadWrite, 0xb0080000 , 0x10000) > > }) > > } > > > > I think that "PNP0C02" should be used to mark any motherboard reserved > > resource and not a specific network driver. > > It seems like a bug in the "fjes" driver.
Extended Socket network device is a shared memory based high-speed network interface between Extended Partitions of PRIMEQUEST 2000 E2 series. To check if firmware supports Extended Socket network device, we take use of "PCP0C02" device and special strings in DSDT. "fjes" is not only "platform device driver (mainly act as network driver" but also "acpi driver" . If "PCP0C02" found and it is for Extended Socket network device, platform_device will be created. Sincerely, Taku Izumi > > > > Thanks > > > > Dongdong > > > > > > > > > > _______________________________________________ > > linuxarm mailing list > > linux...@huawei.com > > http://rnd-openeuler.huawei.com/mailman/listinfo/linuxarm
