Hi Dongdong Thanks for flagging this
+to: Taku Izumi <[email protected]> Gab > -----Original Message----- > From: [email protected] [mailto:[email protected]] > On Behalf Of Dongdong Liu > Sent: 03 June 2016 10:38 > To: [email protected] > Cc: Linuxarm > Subject: [bug discuss] fjes driver call trace warning, "PNP0C02" used > in fjes seems like a bug, > > Hi all: > > The bug is recorded in https://bugs.linaro.org/show_bug.cgi?id=2292. > > "PNP0C02" attached two modules drivers/pnp/system.c and > drivers/net/fjes/fjes_main.c . > "fjes" driver lead to the call trace. > > system.c: > static const struct pnp_device_id pnp_dev_table[] = { > /* General ID for reserving resources */ > {"PNP0c02", 0}, > /* memory controller */ > {"PNP0c01", 0}, > {"", 0} > }; > > jes_main.c: > static const struct acpi_device_id fjes_acpi_ids[] = { > {"PNP0C02", 0}, > {"", 0}, > }; > > Both of the modules use id "PNP0C02" (case insensitive), > > I used "PNP0C02" to mark motherboard reserved resource as below in > UEFI. > Device (RES1) > { > Name (_HID, "HISI0081") // HiSi PCIe RC config baseaddress > Name (_CID, "PNP0C02") // Motherboard reserved resource > Name (_CRS, ResourceTemplate (){ > Memory32Fixed (ReadWrite, 0xb0080000 , 0x10000) > }) > } > > I think that "PNP0C02" should be used to mark any motherboard reserved > resource and not a specific network driver. > It seems like a bug in the "fjes" driver. > > Thanks > > Dongdong > > > > > _______________________________________________ > linuxarm mailing list > [email protected] > http://rnd-openeuler.huawei.com/mailman/listinfo/linuxarm
