Clayton L. Harry came up with the solution, thanks a lot: Select "MapInfo Table" (*.tab) in the Files Type tab in Explorer. Then edit the Open Action and select "Use DDE" insert: Open Table "%1" View Automatic, MapInfo, -blank-, System. Then everything works as intended. I still don't know if it is possible to have more than one hotlink reference in the same table. Do you have any hints on that subject? Venlig Hilsen S�ren Breddam -----Oprindelig meddelelse----- Fra: S�ren Breddam [mailto:[EMAIL PROTECTED]] Sendt: 21. november 2000 11:21 Til: '[EMAIL PROTECTED]' Emne: MI-L Hotlink opens another MI-session Dear list, I'm using hotlink in MI 6.0 to display only selected registered ortofotos in a grid. The hotlink points to the *.tab files. Everything works just fine on my pc, but when I try to use hotlink on other computers in the network, they start a new session (open MI again) and display only the registered foto. I'm not sure if this is relevant, but the fotos and *.tab files are stored on my harddrive as a shared folder, (which is a mapped network drive on the client computers.) ANY suggestions - I'm out of ideas.... Does anybody know if it is possible to store more than one hotlink in the same table? venlig hilsen S�ren Breddam _______________________________________________________________________ List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, send e-mail to [EMAIL PROTECTED] and put "unsubscribe MapInfo-L" in the message body. _______________________________________________________________________ List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, send e-mail to [EMAIL PROTECTED] and put "unsubscribe MapInfo-L" in the message body.
