> On Jun 5, 2018, at 10:19 AM, Thomas Hibbard <thibb...@xgtechservices.com> > wrote: > > Okay, thanks so much for all the information so far, I think I'm beginning to > understand the program a bit more. For the testOnDemandRTSPServer, how do I > run it/make sure I installed it properly? From the page you linked, I should > have it installed just fine since I did the make install command.
The applications in “testProgs” - including “testOnDemandRTSPServer” - should be installed in “/usr/local/bin”. (You will have seen this displayed when you typed “make install”.) > I just want to make sure I'm not messing anything up to where I can't > understand what is going on since I'm still learning this software. Thanks > again for the information thus far. You’re going to have to stop asking so many ‘low level’ questions on this mailing list. This mailing list - which contains more than 1200 busy professionals - is intended for asking detailed technical questions about the software, where the answer can’t be immediately inferred from our online documentation, nor should be immediately obvious to any reasonably experienced C++ systems programmer. If you’re an inexperienced programmer, then you’re going to have to first spend a lot more time getting help from your colleagues. Or perhaps you’ll find that this software is not for you. Ross Finlayson Live Networks, Inc. http://www.live555.com/ _______________________________________________ live-devel mailing list live-devel@lists.live555.com http://lists.live555.com/mailman/listinfo/live-devel
