Okay, thanks so much for all the information so far, I think I'm beginning to understand the program a bit more. For the testOnDemandRTSPServer, how do I run it/make sure I installed it properly? From the page you linked, I should have it installed just fine since I did the make install command. I just want to make sure I'm not messing anything up to where I can't understand what is going on since I'm still learning this software. Thanks again for the information thus far.
-----Original Message----- From: live-devel [mailto:live-devel-boun...@ns.live555.com] On Behalf Of Ross Finlayson Sent: Tuesday, June 5, 2018 12:49 PM To: LIVE555 Streaming Media - development & use <live-de...@ns.live555.com> Subject: Re: [Live-devel] Setting up stream with ffmpeg? > On Jun 5, 2018, at 8:45 AM, Thomas Hibbard <thibb...@xgtechservices.com> > wrote: > > Also, sorry, just saw what you put under the message, my bad, okay, I'll have > to poke around the one application you mentioned, do I have to build that or > is it already built when I generate the files for the main MediaServer itself? Full instructions for how to build the “LIVE555 Streaming Media” software - including the “testOnDemandRTSPServer” demo application - can be found at http://www.live555.com/liveMedia/ Ross Finlayson Live Networks, Inc. http://www.live555.com/ _______________________________________________ live-devel mailing list live-devel@lists.live555.com http://lists.live555.com/mailman/listinfo/live-devel _______________________________________________ live-devel mailing list live-devel@lists.live555.com http://lists.live555.com/mailman/listinfo/live-devel
