Matthew Trescott writes:
> > So at this point, getting the ephy-25mhz enabled by mac and/or mdio
> > drivers should fix things.
> >
> > I placed these in both the mdiobus and phy clauses of the DTS but it's
> > not getting picked up:
> >
> > clocks = <&ccu CLK_EMAC_25M>;
> > clock-names = "ephy25m";
> >
>
> OK, I need to try it out to see if I can find the problem. Maybe someone more
> experienced than me can weight in in the meantime, though.
If I list the phy as discoverable, it isn't detected as the
clocks/reset aren't setup:
compatible = "ethernet-phy-ieee802.3-c22";
[ 1.273000] mdio_bus stmmac-0: MDIO device at address 0 is missing.
Or if I list the phy specifically, mdiobus_register_clock() does get
called, but mdio_device_toggle_clock() is never called:
compatible = "ethernet-phy-id001c.c816";
[ 1.448000] mdio_bus stmmac-0:00: Resources present before probing
--
Dave
--
You received this message because you are subscribed to the Google Groups
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web, visit
https://groups.google.com/d/msgid/linux-sunxi/25964.46726.865540.152010%40gargle.gargle.HOWL.
