On 19/05/2026 09:16, Alexandre MINETTE via B4 Relay wrote: > From: Alexandre MINETTE <[email protected]> > > PM8921/PM8821 provide USB ID detection through the PMIC USB block. The > USB_ID_IN interrupt is exposed by the PM8921 interrupt controller and is > used by APQ8064 platforms for OTG role detection. > > The device is modeled as a child of the SSBI-connected PM8921 PMIC. > Unlike PM8941, the downstream PM8xxx misc device is not instantiated with > a register resource for this path, and the mainline extcon driver only
I could have guessed that at v2, but this suggests that device is not a separate block. If it does not have separate addressing, then it is not a dedicated/separate sub device in the PMIC and your node plus binding should be squashed into the parent. > needs the named USB ID interrupt. Allow qcom,pm8921-misc without requiring > reg. > > Signed-off-by: Alexandre MINETTE <[email protected]> > --- > .../devicetree/bindings/extcon/qcom,pm8941-misc.yaml | 17 > +++++++++++++---- > 1 file changed, 13 insertions(+), 4 deletions(-) Best regards, Krzysztof
