Thank you for your contribution! Sashiko AI review found 1 potential issue(s) to consider: - [Low] Leaking objtool options into vmlinux.o validation causes a fatal build failure (`--cfi requires --prefix`) and silently alters validation behavior. --
commit 68e454f3a8ccd3d638c67c092eee264996286695 Author: Josh Poimboeuf <[email protected]> kbuild: Only run objtool if there is at least one command This commit splits the objtool arguments into commands and options to prevent objtool from running when no commands are enabled. > diff --git a/scripts/Makefile.vmlinux_o b/scripts/Makefile.vmlinux_o > index 527352c222ff6..09af33203bd8d 100644 > --- a/scripts/Makefile.vmlinux_o > +++ b/scripts/Makefile.vmlinux_o [ ... ] > @@ -36,18 +36,13 @@ endif > # For !delay-objtool + CONFIG_NOINSTR_VALIDATION, it runs on both translation > # units and vmlinux.o, with the latter only used for noinstr/unret > validation. > > -objtool-enabled := $(or $(delay-objtool),$(CONFIG_NOINSTR_VALIDATION)) > - > -ifeq ($(delay-objtool),y) > -vmlinux-objtool-args-y += > $(objtool-args-y) > -else > -vmlinux-objtool-args-$(CONFIG_OBJTOOL_WERROR) += --werror > +ifneq ($(delay-objtool),y) > +objtool-cmds-y = > +objtool-opts-y += --link Does this code unintentionally retain the options from scripts/Makefile.lib? Since objtool-cmds-y is cleared here, commands like --prefix are dropped. However, because objtool-opts-y is only appended to, options like --cfi remain active. This causes objtool to fail with a fatal error: "--cfi requires --prefix" during vmlinux.o validation on configurations with KCFI. Should objtool-opts-y be assigned directly using = or := instead of appended? > endif -- Sashiko AI review ยท https://sashiko.dev/#/patchset/[email protected]?part=9
