On Sat, 26 Sep 2020 15:55:14 +0200
Luka Kovacic <[email protected]> wrote:
> + leds {
> + compatible = "gpio-leds";
> + status = "okay";
> + pinctrl-0 = <&cp0_sfpplus_led_pins &cp1_sfpplus_led_pins>;
> + pinctrl-names = "default";
> +
> + led0 {
> + function = LED_FUNCTION_STATUS;
> + label = "p2_act";
> + gpios = <&cp1_gpio1 6 GPIO_ACTIVE_LOW>;
> + };
There should be a dash in LED node name, please pass this dts via
dt_binding_check
led-0 {
...
};
Also why not add the `color` property to the LED? This is DTS for a
specific device, right?
`label` is obsolete. The LED subsystem creates a name in form
[device:]color:function
If this LED should blink for activity on port 2 (is this an ethernet
port?), the function should be LED_FUNCTION_LAN and function-enumerator
should be <2> (or function should be LED_FUNCTION_ACTIVITY, depending
on how the LED subsystem goes forward with this, but certainly not
LED_FUNCTION_STATUS), and trigger-sources should be set to point to the
ethernet port.
Luka, are you willing to change this once we solve this API properly
in LED subsystem?
> + led6 {
> + function = LED_FUNCTION_STATUS;
> + linux,default-trigger = "disk-activity";
> + label = "front-hdd-led";
> + gpios = <&cp0_gpio2 22 GPIO_ACTIVE_HIGH>;
> + };
led-6. LED_FUNCTION_DISK. `label` deprecated.
> + leds {
> + compatible = "iei,wt61p803-puzzle-leds";
> + #address-cells = <1>;
> + #size-cells = <0>;
> +
> + led@0 {
> + reg = <0>;
> + color = <LED_COLOR_ID_BLUE>;
> + label = "front-power-led";
> + };
Again, `label` is deprecated. Rather use function =
<LED_FUNCTION_POWER>;
Marek
